C&S Test Specifications

  • CAN
    ISO 16845-1 Protocol conformance test – Processor Interface – Robustness.
    Low-Speed and High-Speed Transceiver — Partial networking ISO 16845-2.
    Device tests and System tests — Transceiver Model Requirements Specification and Validation Test Specification.
    Communication and Network Management Software Modules.
  • FlexRay
    Protocol and Physical Layers Conformance Test Specifications — Bus Driver Simulation Model Requirements Specification and Model Validation Test Specification — Communication Controller: Device Level Assessment Test Specification — Wake up – Startup – Sleep Test Specification.
  • LIN
    Data Link Layer.
    Physical Layer.
    OEM specific test specifications.
    SAEJ2602 Standalone Transceiver test specification.
  • OSEK
    Network Management.
  • Diagnostic
    Diagnostic communication between test equipment and vehicle over Internet Protocol.


“Automotive Technology Day” 2017

C&S participated with a booth in the 2017 IEEE Standards Association (IEEE-SA) Ethernet & IP @ Automotive Technology Day

Read More

C&S on “Automotive Technology Day” in the Silicon Valley 31.10. – 02.11.2017

A three-headed team will now be flying to San Jose in Silicon Valley, California to attend the IEEE Standards Associatio

Read More

ReAccreditation ISO 17025:2005

On 31.08.2017 it was time again: The assessment for re-accreditation according to the quality standard ISO 17025: 2005

Read More
Load More News

Copyrighted Image